VEA-1002
Analog Video Distribution Amplifier with EQ
The VEA-1002 is an analog video distribution amplifier with eight outputs, providing equalization and differential input. The VEA-1002 will equalize up to 300m (984 ft.) of Belden 8281 cable. Gain and equalization are controlled from the card edge. Signal status is provided to indicate the input signal presence. The differential input provides rejection of hum and other artifacts on incoming signals.

FEATURES
- Analog video differential input with passive loop-through
- 8x 75 ohm outputs
- Supports NTSC and PAL video standards
- 50 MHz analog video bandwidth
- Equalization up to 300m (984 ft.)
- Control of equalization and gain from the card edge
- Status LED and remote reporting
SPECIFICATIONS
Input
- Signal: Any 1 Vp-p nominal signal
- Return loss: >35 dB up to 5.75 MHz
- Coupling: DC or AC with clamping
- Level: 0.3 to 1.5 Vp-p
- Impedance: 75Ω bridging
- Max. common mode signal: 28 Vp-p
- Common mode rejection: >65 dB to 10 kHz
Output
- Signal (3-8): 1 Vp-p nominal signal, adjustable
- Return loss: >35 dB up to 5.75 MHz
- Impedance: 75Ω
- Phase match between outputs: <0.1° at 4.43 MHz
- Output isolation signal: >40 dB at 10 MHz
- Response variation: <0.1 dB, 1 to 8 loads, to 20 MHz
Processing Performance
- Gain range: ±3 dB
- Freq. response: ±0.05 dB up to 5 MHz
- ±0.15 dB up to 10 MHz
- EQ range: 0-300m (0-984 ft.) using Belden 8281
- EQ response:
- <±0.05 dB up to 5 MHz
- ±0.1 dB up to 10 MHz,
- -3 dB at 30 MHz typically
- Differential gain: <0.15%
- Diff. phase:
- <0.15° at 8 loads
- <0.1° at 2 loads
- H/V tilt: <0.1%, DC coupling
- SNR: >70 dB up to 15 MHz (rms noise/0.714V, unweighted)
- Chrominance/luminance delay error: <±1 ns
- Chrominance/luminance gain error: <±0.02 dB
- Hum: <1 mV
- Latency: 5 ns
Electrical
- Power:
- 2W (SRP)
- 2.5W (DRP, 3SRP)
MEDIA GALLERY


ORDERING INFORMATION
Densité 2 frame | Densité 3 frame | Description |
VEA-1002 | VEA-1002-3RU | Analog video equalizing DA |
VEA-1002-SRP | Single rear connector panel with 4 outs | |
VEA-1002-SRP/L | VEA-1002-SRP/L-3RU | Single rear connector panel |
VEA-1002-DRP | VEA-1002-DRP-3RU | Double rear connector panel |
VEA-1002-3SRP | Single rear connector panel with 7 outs | |
Remote control | iControl, iControl Solo, RCP-200 |